Fault Message; Calling Up Fault Indication - Bosch MPC-xxxx-B Operation Manual

Panel controller
Table of Contents

Advertisement

Panel Controller
10

Fault message

This chapter contains information about the following points:
10.1

Calling up fault indication

NOTICE!
If a fire alarm is reported, the system automatically switches to alarm indication.
To return to the fault indication, select Fault on the status bar.
In the event of a fire alarm, the display automatically switches back to the alarm indication
after 30 seconds.
To display the fault messages from the alarm indication or any other menu, select the
following on the status bar:
CAUTION!
If a message does not have to be reset, it is removed from the display as soon as the fault has
been rectified.
NOTICE!
If individual elements that are combined with other elements in a group are malfunctioning,
the respective element group is displayed first of all. To display the individual elements, select
the element group you require. See also Section 10.2.5 Displaying individual elements of an
element group, page 51.
Bosch Sicherheitssysteme GmbH
Section 10.1 Calling up fault indication, page 49
Section 10.2 Trouble message on the panel, page 50
Section 9.3 Switching off internal buzzer, page 45
Section 10.3 Resetting malfunction message, page 53
Section 10.4 Isolating an element, page 53
Fault: A list of all reported fault types and the number of faulty elements are displayed.
Status: A list of all current messages, grouped by message type, is displayed. The number
of elements is also given in each case.
To display the fault messages, select the message category you require — in this case,
Fault.
0
0
Fire
Control
Operation guide
8
0
Trouble
Bypass
Status
Fault message | en
49
F.01U.076.969 | 6.0 | 2010.04

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fpa-1200-mpc

Table of Contents