Detector Sensitivity - Bosch MPC-xxxx-B Operation Manual

82 en | Configuration
Isolate Group
To display the elements in an isolate group and to delete or add elements, repeat the steps,
but select Block Group in step 3.
Walktest Group
To display the elements in a walktest group and to delete or add elements, see
Section 15.1 Walktest groups, page 68.
18.4

Detector sensitivity

CAUTION!
Detector sensitivity is automatically reset to the default setting
–
–
Two different sensitivities can be assigned to detectors and logical zones in the FSP-5000-
RPS programming software — a default setting and an alternative setting.
It is possible to switch between the default and alternative setting on the panel controller.
To change the setting:
1.
2.
3.
4.
5.
6.
F.01U.076.969 | 6.0 | 2010.04
When the entire panel or the individual detector/logical zone is reset
When the detector is replaced
Select Configuration in the start menu
Detector sensitivity
Various lists are offered. Refer to Section 5.6.1 Scrolling through lists, page 28 for
information on how to scroll forward and backward through a list.
Select one of the detector or logical zone lists that are offered.
A list of elements is displayed. Refer to Section 5.6.1 Scrolling through lists, page 28 for
information on how to scroll forward and backward through the list.
Depending on the list you have selected, enter the number or the name of the element
into the search screen, Section 5.7 Search Function/Element, page 30.
Select the list field you require, e.g. a logical zone in this case.
Two settings are displayed: There is a checkmark in the selection field in front of the
active setting.
Select the selection field of the detector sensitivity you require.
A checkmark is set in this field.
Select OK to confirm the selection or Cancel to cancel the operation.
The selected detector sensitivity is confirmed for the detector.
Operation guide
Panel Controller
Bosch Sicherheitssysteme GmbH