Set Default Password; Rename Elements; Overview - Bosch MPC-xxxx-B Operation Manual

84 en | Configuration
18.5.3

Set Default Password

1.
2.
3.
4.
5.
18.6

Rename elements

To change the name an element:
1.
2.
3.
4.
5.
18.7

Overview

To display important information on the valid configuration of the system:
1.
2.
F.01U.076.969 | 6.0 | 2010.04
Select Configuration in the start menu
Operator
Set default password
A list of all operators is displayed. Refer to Section 5.6.1 Scrolling through lists, page 28
for information on how to scroll forward and backward through a list.
Select the list field you require.
The list field is marked.
Select Reset.
The operator's password is reset to his/her previous password.
Select Configuration in the start menu
Rename elements
A list of all elements is displayed. Refer to Section 5.6.1 Scrolling through lists, page 28 for
information on how to scroll forward and backward through a list.
Select the list field you require.
An entry screen is displayed.
Enter a new name. Refer to Section 5.8 Entering numbers and text, page 31 for information
on how to enter text.
Select OK to confirm the entry or Cancel to cancel the operation.
The event with the new name is displayed on the list.
Select Configuration in the start menu
Overview
The following information is displayed:
– Configuration and additional information on this
– Date
– Configuration version (Config. version)
– Number
– Name
– IP address
– Scope
– Country
– Time zone
– Menu name
Operation guide
Panel Controller
Bosch Sicherheitssysteme GmbH