Panel Controller
6.
To un-bypass the elements again, repeat all previous steps, but select Un-bypass in step 6.
NOTICE!
Depending on the configuration and the structure of the panel, it is possible that signaling
devices cannot be bypassed individually but only all at once. In this case, the NAC All list field
is offered in step 4 instead of the selection list.
11.3
Displaying and un-bypassing bypassed element groups
1.
2.
3.
4.
11.4
Displaying list of all bypassed elements
There are two ways to display a list of all bypassed elements:
–
–
11.4.1
Using the menu
To display a list of all bypassed elements, select the following in the start menu:
1.
2.
3.
4.
To un-bypass bypassed elements:
1.
2.
Bosch Sicherheitssysteme GmbH
Select Bypass.
The selected elements are bypassed.
In the Bypass field on the status bar, the number of bypassed elements is increased by
two elements.
There are two ways to display all partly or completely bypassed loops, logical zones etc.:
–
Select Bypass on the status bar
A list of various states is displayed. Or
–
In the start menu, select Bypass Block.
Select either Bypassed or Bypass and then Show bypassed devices.
A list of various element categories is displayed.
The listed number displays the number of bypassed elements or element groups in the
relevant element category.
Select the list field you require, e.g. logical zone.
Select:
–
Partly bypassed to display all partly bypassed logical zones;
–
Completely bypassed to display all completely bypassed logical zones.
Depending on which option you select, all partly bypassed or fully bypassed logical zones
will be displayed. The number in parentheses, e.g. (5) specifies the number of bypassed
elements.
To un-bypass all elements in one or more logical zones, select the logical zone you
require and select Un-bypass.
Section 11.4.1 Using the menu, page 55
Section 11.4.2 Via the status bar, page 56
Bypass Block
Bypass
Show bypassed devices
A list of various element categories is displayed.
The listed number displays the number of bypassed elements or element groups in the
relevant element category.
Select the element category you require, e.g. Detector.
A list of all bypassed detectors is displayed:
Select the element you require.
Select Un-bypass.
The element is un-bypassed.
Operation guide
Bypass | en
55
F.01U.076.969 | 6.0 | 2010.04