Signals; Resetting Malfunction Message; Isolating An Element - Bosch MPC-xxxx-B Operation Manual

Panel Controller
10.2.8

Signals

Optical signals
An internal buzzer sounds on the panel and the "fault" signal light turns yellow.
Depending on the type of fault, an additional yellow signal light lights up (see also
Section 4.2 Display elements, page 21):
–
–
–
Acoustic signal
An internal signal tone sounds on the system.
To temporarily switch off the internal buzzer:
Press the "Signal tone off" key.
The internal signal tone is switched off.
10.3

Resetting malfunction message

CAUTION!
If a message does not have to be reset, it is removed from the display as soon as the fault has
been rectified.
Depending on the configuration, three different variants are offered for resetting; see
Section 9.7 Resetting alarm message, page 47.
There are two ways to reset a fault message:
–
–
If a list field is marked with an "R", the process of resetting is not yet complete for this
element.
TEXT
If an element cannot be reset, it will continue to be displayed in the list.
After the successful resetting of all elements, the standby display is displayed.
10.4

Isolating an element

In order to isolate an element that has caused a fault:
1.
2.
CAUTION!
The system does not transmit any information as to whether it was possible to isolate the
selected element. To monitor the operation, check the element.
Bosch Sicherheitssysteme GmbH
Fault System
Fault Transmission Device
Fault Signals
Select Reset in the message display or
Select the fault message and then press Reset in the detailed view
The selected element/element group is reset.
R
Select the fault message you require.
Select Block.
Operation guide
Fault message | en 53
F.01U.076.969 | 6.0 | 2010.04