Fire Alarm; Optical And Acoustic Signals; Acknowledging A Message - Bosch MPC-xxxx-B Operation Manual

44 en | Fire alarm
9

Fire alarm

NOTICE!
Detailed information about types of alarms, alarm delays and the panel controller display can
be found in Section 8 Alarm, page 38.
This chapter contains information about the following points:
–
–
–
–
–
–
–
Signaling fire alarms
A fire alarm is signaled optically and acoustically on the panel through:
–
–
–
NOTICE!
Alarm messages have the highest priority compared with all other message types. If a fire
alarm is reported, the system switches automatically to alarm indication.
9.1

Optical and acoustic signals

–
–
–
If the transmission device to the fire department is activated, the Transmission Device
activated LED display lights up red:
9.2

Acknowledging a message

There are two ways to acknowledge messages:
–
–
NOTICE!
If Go to Acknowledge is displayed, select this field in order to display the messages that have
not yet been acknowledged.
F.01U.076.969 | 6.0 | 2010.04
Section 9.2 Acknowledging a message, page 44
Section 9.3 Switching off internal buzzer, page 45
Section 9.4 Switching external signaling devices on and off, page 45
Section 9.5 Resetting external signaling devices and transmission devices, page 45
Section 9.6 Triggering fire verification, page 46
Section 9.7 Resetting alarm message, page 47
Section 9.8 Bypassing detectors, page 48
Displaying the logical zones on the display
Lighting up the "Alarm" LED display
An internal buzzer sounds on the system.
The red alarm signal light on the LED display lights up
An internal buzzer sounds; see also Section 9.3 Switching off internal buzzer, page 45.
Depending on the configuration, sounders and/or optical signaling devices (e.g. sirens,
strobes) are activated.
Select Acknowledge.
Only those alarm messages which are visible in the display are acknowledged.
Select a message and then press Acknowledge. Only the selected message is
acknowledged.
Operation guide
Panel Controller
Bosch Sicherheitssysteme GmbH