Changing The Time For Resetting To Night Mode - Bosch MPC-xxxx-B Operation Manual

78 en | Day and night mode
17.3

Changing the time for resetting to night mode

CAUTION!
After the system starts up following a power cut or battery failure, the default set back time in
FSP-5000-RPS is reset.
NOTICE!
Depending on the configuration, the set back time can be changed. It is only possible to make
a change for the current day. It is only possible to make a change if a specified time has
already been set for the current day in the programming software.
The set back time can be changed in day or night mode.
To change the time for resetting in night mode:
1.
2.
3.
4.
To change the set back time in day mode to night mode:
1.
2.
3.
4.
F.01U.076.969 | 6.0 | 2010.04
On the status bar, select
or
select Switch to day mode in the start menu.
Select Change time.
Enter the numbers you require.
Refer to Section 5.8 Entering numbers and text, page 31 for information on how to enter
numbers.
Select OK to confirm the entry or Cancel to cancel the operation.
The entries are confirmed.
On the status bar, select
or
select Switch to night mode in the start menu.
Select Change time.
Enter the numbers you require.
Refer to Section 5.8 Entering numbers and text, page 31 for information on how to enter
numbers.
Select OK to confirm the entry or Cancel to cancel the operation.
Operation guide
Panel Controller
Bosch Sicherheitssysteme GmbH