Configuration; Switching To Day Or Night Mode - Bosch MPC-xxxx-B Operation Manual

16 en | All functions at a glance
3.5

Configuration

Configuration
Set input / output groups
–
–
–
–
Set groups
–
–
–
–
Detector sensitivity
Change the sensitivity of individual detectors or zones. Two selection options are available: a
default sensitivity and an alternative sensitivity assigned in the FSP-5000-RPS programming
software.
Operator
If the same password is used per access level, the following options are offered:
–
If every user has a different password, the following options are offered:
–
–
Rename elements
Change the description of the elements.
Overview
Information on valid configuration of the system.
3.6

Switching to day or night mode

–
–
F.01U.076.969 | 6.0 | 2010.04
-> Set input / output groups Set groups
Detector sensitivity
Rename elements
Input group or Output group
Displaying the assigned elements.
Add or delete elements.
Rename group names.
Bypass group, isolate group or walktest group
Displaying the assigned elements.
Add or delete elements.
Rename walktest, bypass and isolate groups.
Change universal password
The same password can be configured for each access level in the FSP-5000-RPS
programming software. The password for access levels two to four can be changed.
Change operator data
Change a user's password.
Set default password
Reset an operator's password to his/her previous password.
Switch to day or night mode
In day mode: Set the reset time to night mode for the current day.
Operation guide
Operator
Overview
Bosch Sicherheitssysteme GmbH
Panel Controller