26
en | Operating principle
4.
As long as an operator is logged in, the key icon will be displayed on the info bar.
In addition, the user ID of the user who has logged on is displayed on the start page on the
info bar.
NOTICE!
In the FSP-5000-RPS programming software, a time span can be specified after which an
operator who is logged in to the panel controller is logged out.
5.1.2
Logging out
1.
2.
5.2
Access authorization
NOTICE!
Depending on your access authorization, you can only use certain functions of the panel
controller.
If you select a function for which a particular access authorization is required and no user with
the appropriate authorization is logged on, you will be asked to enter your user ID and
password.
Access authorizations are assigned for access levels two to four. Only a few functions can be
used on access level one, while all functions can be used on access level four.
To check the access authorization of the person who is logged in, press the "key" key after
logging in:
The relevant access authorization is displayed.
5.3
Calling up the start menu
Press the "home" key to return to the start menu from any submenu.
NOTICE!
The display changes from each menu element to the standby display if no entries are made
within one minute; see also Section 4.4 Standby display, page 23.
5.4
Selecting the menu
In order to select a menu in the start menu, touch the field you require with your finger:
The submenus are displayed.
To select a submenu, gently touch the required field.
F.01U.076.969 | 6.0 | 2010.04
Select OK to confirm the entries or Cancel to cancel the operation.
Refer to Section 19.5 Change password, page 87 for information on how to set up your
own password.
The standby display is shown.
To log out of the panel controller, press the "key" key:
An input window with the request Log off? is displayed:
Select Yes to confirm the request or No to cancel the operation.
Operation guide
Panel Controller
Bosch Sicherheitssysteme GmbH