Trouble Message On The Panel; Acknowledging A Message; Sequence Of The Trouble Messages; Information About Malfunctioning Element Groups - Bosch MPC-xxxx-B Operation Manual

50 en | Fault message
10.2

Trouble message on the panel

10.2.1

Acknowledging a message

There are two ways to acknowledge messages:
–
–
Element groups
Logically addressed logical zones are displayed in a list.
List fields with black background indicate unacknowledged fault messages.
List fields without distinction indicate acknowledged fault messages.
NOTICE!
A maximum of four fault messages can be displayed on the display at any time.
Only fields that can be operated are displayed (e.g. Acknowledge and Reset).
To display further fault messages, scroll down through the list. Refer to Section 5.6.1 Scrolling
through lists, page 28 for information on how to scroll through a list.
The next four fault messages are displayed.
10.2.2

Sequence of the trouble messages

The messages are displayed in chronological order.
NOTICE!
15–30 seconds after the last entry (e.g. after scrolling through the list), the first and last fault
message is displayed at the beginning of the list again.
10.2.3

Information about malfunctioning element groups

The trouble message contains information about:
–
–
–
–
–
–
F.01U.076.969 | 6.0 | 2010.04
Acknowledging all displayed messages:
Select Acknowledge.
Acknowledging an individual message:
First select the message and then press Acknowledge.
Element category
Message type
Address of the element group
Number of individual elements that have caused a fault in the respective element group
Message number
Additional information (e.g. the installation location, depending on the configuration)
Operation guide
Panel Controller
Bosch Sicherheitssysteme GmbH