Displaying The Individual Detectors In A Logical Zone; Information About Individual Detectors; Displaying Additional Information - Bosch MPC-xxxx-B Operation Manual

Panel Controller
8.4.6

Displaying the individual detectors in a logical zone

To display the individual detectors in a logical zone, select the logical zone you require.
The alarm messages for the individual detectors are listed.
8.4.7

Information about individual detectors

Each alarm message contains information about:
–
–
–
–
–
Example:
Fire
#002
Message type
Refer to Section 8.4.4 Information about logical zones in the alarm state for information on the
type of message.
Message address
In this example, the following detector has triggered a fire alarm:
0005 - 004: the fourth detector (004) in the fifth logical zone (00005).
If the detector number, in this case (004), is not displayed, this is the alarm message for the
logical zone.
NOTICE!
Depending on the configuration of the system, either the logical or physical address of the
detector is displayed.
Message number
For information on the message number (#002), see Section 8.4.4 Information about logical
zones in the alarm state.
Depending on the configuration, additional information is displayed in the second line, such
as the installation location of the detector or the detector type.
To display more information about an alarm message, see Section 8.4.8 Displaying additional
information.
8.4.8

Displaying additional information

NOTICE!
By way of example, an action text can be entered for every detector type in the FSP-5000-RPS
programming software.
To display further information about the individual detectors, select the alarm message you
require.
The following information is displayed:
–
–
–
–
–
–
Bosch Sicherheitssysteme GmbH
The element category
The message type
The detector address
The message number
Depending on the configuration, additional information such as the installation location
Detectors
Office 1
Element category
Message type
Date and time of the message
Physical and logical addressing of the detector
Only for LSN detectors: specification of the detector type
Action text (depending on the configuration)
Operation guide
00005 - 004
Alarm | en 43
F.01U.076.969 | 6.0 | 2010.04