Displaying List Of All Isolated Elements; Using The Menu; Via The Status Bar - Bosch MPC-xxxx-B Operation Manual

58 en | Isolate
12.3

Displaying list of all isolated elements

There are two ways to display a list of all isolated elements:
–
–
12.3.1

Using the menu

To display a list of all isolated elements, select the following in the start menu:
1.
2.
3.
4.
To de-isolate isolated elements:
1.
2.
12.3.2

Via the status bar

To display a list of all isolated elements:
1.
2.
3.
To de-isolate isolated elements:
1.
2.
F.01U.076.969 | 6.0 | 2010.04
Section 12.3.1 Using the menu, page 58
Section 12.3.2 Via the status bar, page 58
Bypass Block
Block
Show blocked devices
A list of various element categories is displayed.
The listed figure indicates the number of isolated elements or element groups in the
relevant element category.
Select the element category you require, e.g. Detector.
A list of all isolated detectors is displayed.
Select the element you require.
Select Un-block.
The element is de-isolated.
Select Bypass on the status bar.
A list of various states is displayed.
Select Blocked.
A list of various element categories is displayed.
The listed figure indicates the number of isolated elements or element groups in the
relevant element category.
Select the list field you require, e.g. Detector.
A list of all isolated elements is displayed.
Select the element you require.
Select Un-block.
The element is de-isolated.
Operation guide
Panel Controller
Bosch Sicherheitssysteme GmbH