Configuration; Menu Overview; Input / Output Group Set Up; Adding Or Deleting Elements - Bosch MPC-xxxx-B Operation Manual

Panel Controller
18

Configuration

This chapter contains information about the following points:
–
–
–
–
–
–
18.1

Menu overview

Configuration
18.2

Input / Output Group Set Up

Input and output groups can be created using the FSP-5000-RPS programming software:
Input groups consist of several detectors and/or logical zones;
Output groups consist of signaling devices and transmission devices.
Specify which input group activates which output group by using the programming software.
The following can be carried out on the panel controller:
–
–
18.2.1

Adding or deleting elements

Input group
In order to add elements to an input group or remove elements from it:
1.
2.
3.
4.
5.
Bosch Sicherheitssysteme GmbH
Section 18.2 Input / Output Group Set Up, page 79
Section 18.3 Group setting, page 81
Section 18.4 Detector sensitivity, page 82
Section 18.5 Operator, page 83
Section 18.6 Rename elements, page 84
Section 18.7 Overview, page 84
-> Set input / output groups Set groups
Detector sensitivity
Rename elements
Elements can be added to, or removed from input or output groups.
Input or output groups can be renamed.
Select Configuration in the start menu
Set input / output groups
Input group
Two different lists are displayed. See Section 5.6 Working with lists, page 27.
Select a list, e.g. By description.
A list of the various input groups is displayed. Refer to Section 5.6.1 Scrolling through
lists, page 28 for information on how to navigate through a list.
Select the list field you require.
The list field is marked.
You can select various options:
– Delete all: Delete all elements in the selected input group.
– Show / Change: Display all elements in the selected input group and delete
individual elements.
– Add: Display all elements that have not yet been assigned to an input group, and add
individual elements.
– Cancel: Cancel the operation.
To change the name of the input group, see Section 18.2.2 Change name, page 81.
Operation guide
Configuration | en
Operator
Overview
F.01U.076.969 | 6.0 | 2010.04
79