Assigning Tested Elements To A Walktest Group - Bosch MPC-xxxx-B Operation Manual

72 en | Maintenance – walktest
15.5

Assigning tested elements to a walktest group

NOTICE!
Only those elements in the current walktest that have been tested can be assigned to a
different walktest group.
On completion of the walktest, you can assign the tested elements to a different walktest
group (for the next walktest, for example):
1.
2.
F.01U.076.969 | 6.0 | 2010.04
Select Exit from the status bar.
Various possibilities are offered on the display:
Select Assign tested elements to walktest group to assign the tested elements from the
current walktest to a walktest group for the next walktest:
A list of the walktest groups is displayed.
Select a walktest group from the list. Refer to Section 5.6.1 Scrolling through lists,
page 28 for information on how to navigate through a list.
Two possibilities are offered on the display:
– Select Add to walktest group to assign the tested elements from the current
walktest to a selected walktest group.
– Select Overwrite walktest group to replace the elements in the selected walktest
group with the tested elements from the current walktest.
Operation guide
Panel Controller
Bosch Sicherheitssysteme GmbH