Standby Display - Bosch MPC-xxxx-B Operation Manual

Panel Controller
Status bar
This status bar is available on each menu. In addition, other status bars are offered in some
menus; see also Section 5.10 Switching between status bars, page 33:
The leading number specifies the number of elements in the respective state:
Fire
Control
Trouble
Bypass
In addition it is possible to display an overview of the type and nature of all message types
received by the panel:
Status
To display the individual elements, touch the relevant field with your finger.
The Control and Trouble status fields are identified by the letters "B" and/or "C":
–
–
4.4

Standby display

If the panel is in standby mode, the standby display is shown.
NOTICE!
The display changes from each menu element to the standby display if no entries are made
within ten minutes.
If a gray display is shown, gently touch the touch screen to show the standby display
On the standby display, the following information is displayed:
–
–
or
Depending on the configuration, additional information may be displayed.
In a networked fire detection system, further icons can be displayed in the standby display
depending on the network setting; see Section 6 Networked panels, page 34.
Bosch Sicherheitssysteme GmbH
0 0
Fire Control
Elements that have triggered a fire alarm
Elements that are activated
Elements that have reported a fault
Bypassed or isolated elements
Display of a list of the various message and status types and the
number of elements in the respective state
"B" means that controllers for type B fire safety equipment (G-B) are affected (e.g.
control elements without acknowledgement).
"C" means that controllers for type C fire safety equipment (G-C) are affected (e.g.
extinguishing systems).
Date
Time
Night mode
Day mode
Operation guide
8 0
Trouble Bypass Status
In overview | en 23
F.01U.076.969 | 6.0 | 2010.04