The Anti-Spam Policy Add Or Edit Screen; Figure 423 Anti-X > Anti-Spam > General > Add - ZyXEL Communications 200 Series User Manual

Table 177 Anti-X > Anti-Spam > General
LABEL
Add icon
Apply
Reset

33.3.1 The Anti-Spam Policy Add or Edit Screen

Click the Add or Edit icon in the Anti-X > Anti-Spam > General screen to display the
configuration screen as shown next. Use this screen to configure an anti-spam policy that
controls what traffic direction of e-mail to check, which e-mail protocols to scan, the scanning
options, and the action to take on spam traffic.
Figure 423 Anti-X > Anti-Spam > General > Add
ZyWALL USG 100/200 Series User's Guide
DESCRIPTION
Click the Add icon in the heading row to add a new first entry.
The Active displays whether the entry is enabled or not. Click it to activate or
deactivate the entry. Make sure you click Apply to save and apply the change.
Click the Edit icon to go to the screen where you can edit the entry on the ZyWALL.
Click the Add icon in an entry to add an entry below the current entry.
Click the Remove icon to delete an existing entry from the ZyWALL. A window
displays asking you to confirm that you want to delete the entry. Note that
subsequent entries move up by one when you take this action.
In a numbered list, click the Move to N icon to display a field to type an index
number for where you want to put that entry and press [ENTER] to move the entry
to the number that you typed. For example, if you type 6, the entry you are moving
becomes number 6 and the previous rule 6 (if there is one) gets pushed up (or
down) one.
The ordering of your policies is important as they are applied in order of their
numbering.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
Chapter 33 Anti-Spam
563