Sbus<N>:Lin:trigger - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

:SBUS<n>:LIN:TRIGger
Command Syntax
:SBUS<n>:LIN:TRIGger <condition>
<condition> ::= {SYNCbreak | ID | DATA}
The :SBUS<n>:LIN:TRIGger command sets the LIN trigger condition to be:
• SYNCbreak — Sync Break.
• ID — Frame ID.
• DATA — Frame ID and Data.
Query Syntax
:SBUS<n>:LIN:TRIGger?
The :SBUS<n>:LIN:TRIGger? query returns the current LIN trigger value.
Return Format
<condition><NL>
<condition> ::= {SYNC | ID | DATA}
Errors •
See Also
•
•
•
•
•
•
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
Use the :SBUS<n>:LIN:TRIGger:ID command to specify the frame ID.
Use the :SBUS<n>:LIN:TRIGger:ID command to specify the frame ID.
Use the :SBUS<n>:LIN:TRIGger:PATTern:DATA:LENGth and
:SBUS<n>:LIN:TRIGger:PATTern:DATA commands to specify the data
string length and value.
"- 241, Hardware missing"
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 944
":SBUS<n>:LIN:TRIGger:ID"
":SBUS<n>:LIN:TRIGger:PATTern:DATA:LENGth"
":SBUS<n>:LIN:TRIGger:PATTern:DATA"
":SBUS<n>:LIN:SIGNal:DEFinition"
":SBUS<n>:LIN:SOURce"
on page 1169
on page 935
on page 742
on page 743
on page 1161
on page 738
:SBUS<n> Commands
on page 745
28
741