17
:FUNCtion<m> Commands
:FUNCtion<m>:OPERation
Command Syntax
:FUNCtion<m>:OPERation <operation>
<m> ::= 1-4 in NR1 format
<operation> ::= {ADD | SUBTract | MULTiply | DIVide | DIFF | INTegrate
The :FUNCtion<m>:OPERation command sets the desired waveform math
operator, transform, filter or visualization:
• Operators:
• Transforms:
• Filters:
358
(see
page
1208)
| FFT | SQRT | MAGNify | ABSolute | SQUare | LN | LOG | EXP | TEN
| LOWPass | HIGHpass | AVERage | LINear | TRENd | BTIMing | BSTate}
•
ADD — Source1 + source2.
•
SUBTract — Source1 - source2.
•
MULTiply — Source1 * source2.
•
DIVide — Source1 / source2.
Operators perform their function on two analog channel sources.
•
DIFF — Differentiate
•
INTegrate — The INTegrate:IOFFset command lets you specify a DC
offset correction factor.
•
FFT — The SPAN, CENTer, VTYPe, and WINDow commands are used
for FFT functions. When FFT is selected, the horizontal cursors
change from time to frequency (Hz), and the vertical cursors change
from volts to decibel (dB).
•
LINear — Ax + B — The LINear commands set the gain (A) and offset
(B) values for this function.
•
SQUare
•
SQRT — Square root
•
ABSolute — Absolute Value
•
LOG — Common Logarithm
•
LN — Natural Logarithm
•
EXP — Exponential (e
•
TEN — Base 10 exponential (10
Transforms operate on a single analog channel source or on lower math
functions.
•
LOWPass — Low pass filter — The FREQuency:LOWPass command
sets the - 3 dB cutoff frequency.
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
x
)
x
)