Autoscale:fdebug - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

:AUToscale:FDEBug

Command Syntax
:AUToscale:FDEBug <on_off>
<on_off> ::= {{1 | ON} | {0 | OFF}}
The :AUToscale:FDEBug command turns fast debug auto scaling on or off.
The Fast Debug option changes the behavior of :AUToscale to let you make
quick visual comparisons to determine whether the signal being probed is
a DC voltage, ground, or an active AC signal.
Channel coupling is maintained for easy viewing of oscillating signals.
Query Syntax
:AUToscale:FDEBug?
The :AUToscale:FDEBug? query returns the current autoscale fast debug
setting.
Return Format
<on_off><NL>
<on_off> ::= {1 | 0}
See Also •
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
"Introduction to Root (:) Commands"
":AUToscale" on page 193
Root (:) Commands
on page 190
6
197