Channel<N>:Label - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

:CHANnel<n>:LABel
Command Syntax
:CHANnel<n>:LABel <string>
<string> ::= quoted ASCII string
<n> ::= 1 to (# analog channels) in NR1 format
Label strings are 10 characters or less, and may contain any commonly used ASCII
N O T E
characters. Labels with more than 10 characters are truncated to 10 characters. Lower case
characters are converted to upper case.
The :CHANnel<n>:LABel command sets the analog channel label to the
string that follows. Setting a label for a channel also adds the name to the
label list in non- volatile memory (replacing the oldest label in the list).
Query Syntax
:CHANnel<n>:LABel?
The :CHANnel<n>:LABel? query returns the label associated with a
particular analog channel.
Return Format
<string><NL>
<string> ::= quoted ASCII string
See Also
•
•
•
•
•
Example Code
See complete example programs at:
starting on page 1217
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
"Introduction to :CHANnel<n> Commands"
":DISPlay:LABel" on page 317
":DIGital<d>:LABel" on page 304
":DISPlay:LABList" on page 318
":BUS<n>:LABel" on page 250
' LABEL - This command allows you to write a name (10 characters
' maximum) next to the channel number.
' can be useful for organizing the display.
myScope.WriteString ":CHANnel1:LABel ""CAL 1"""
myScope.WriteString ":CHANnel2:LABel ""CAL2"""
:CHANnel<n> Commands
on page 264
It is not necessary, but
' Label ch1 "CAL 1".
' Label ch1 "CAL2".
Chapter 41, "Programming Examples,"
10
271