Sbus<N>:Usb:trigger - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

28
:SBUS<n> Commands
:SBUS<n>:USB:TRIGger
Command Syntax
:SBUS<n>:USB:TRIGger <condition>
<condition> ::= {SOP | EOP | ENTersuspend | EXITsuspend | RESet
The :SBUS<n>:USB:TRIGger command specifies the USB trigger mode for
the selected bus.
Query Syntax
:SBUS<n>:USB:TRIGger?
The :SBUS<n>:USB:TRIGger? query returns the specified USB trigger mode.
Return Format
<condition><NL>
<condition> ::= {SOP | EOP | ENT | EXIT | RES | TOK | DATA | HAND
See Also
•
•
•
•
800
(see page 1208)
| TOKen | DATA | HANDshake | SPECial | ALLerrors
| PIDerror | CRC5error | CRC16error | GLITcherror
| STUFFerror | SE1error}
| SPEC | ALL | PID | CRC5 | CRC16 | GLIT | STUFF
| SE1}
":SBUS<n>:USB:TRIGger:PID:DATA"
":SBUS<n>:USB:TRIGger:PID:HANDshake"
":SBUS<n>:USB:TRIGger:PID:SPECial"
":SBUS<n>:USB:TRIGger:PID:TOKen"
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 810
on page 811
on page 812
on page 813