20
:MARKer Commands
:MARKer:XUNits
Command Syntax
:MARKer:XUNits <units>
<units> ::= {SEConds | HERTz | DEGRees | PERCent}
The :MARKer:XUNits command sets the X cursors units:
• SEConds — for making time measurements.
• HERTz — for making frequency measurements.
• DEGRees — for making phase measurements. Use the
• PERCent — for making ratio measurements. Use the
Changing X units affects the input and output values of the
:MARKer:X1Position, :MARKer:X2Position, and :MARKer:XDELta
commands/queries.
Query Syntax
:MARKer:XUNits?
The :MARKer:XUNits? query returns the current X cursors units.
Return Format
<units><NL>
<units> ::= {SEC | HERT | DEGR | PERC}
See Also
•
•
•
•
•
•
•
400
(see
page
1208)
:MARKer:XUNits:USE command to set the current X1 location as 0
degrees and the current X2 location as 360 degrees.
:MARKer:XUNits:USE command to set the current X1 location as 0
percent and the current X2 location as 100 percent.
"Introduction to :MARKer Commands"
":MARKer:XUNits:USE"
":MARKer:X1Y1source"
":MARKer:X2Y2source"
":MEASure:SOURce"
":MARKer:X1Position"
":MARKer:X2Position"
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 392
on page 401
on page 396
on page 398
on page 458
on page 395
on page 397