Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 645

Control the modes and parameters for each serial bus decode/trigger type.
See:
• "Introduction to :SBUS<n> Commands"
• "General :SBUS<n> Commands"
• ":SBUS<n>:A429 Commands"
• ":SBUS<n>:CAN Commands"
• ":SBUS<n>:FLEXray Commands"
• ":SBUS<n>:I2S Commands"
• ":SBUS<n>:IIC Commands"
• ":SBUS<n>:LIN Commands"
• ":SBUS<n>:M1553 Commands"
• ":SBUS<n>:SPI Commands"
• ":SBUS<n>:UART Commands"
• ":SBUS<n>:USB Commands"
Introduction to
The :SBUS subsystem commands control the serial decode bus viewing,
:SBUS<n> mode, and other options.
Commands
These commands are only valid on oscilloscope models when a serial decode option has
N O T E
been licensed.
The following serial bus decode/trigger types are available (see
":TRIGger:MODE"
• CAN (Controller Area Network) triggering— will trigger on CAN
version 2.0A and 2.0B signals. Setup consists of connecting the
oscilloscope to a CAN signal. Baud rate, signal source, and signal
polarity, and type of data to trigger on can be specified. You can trigger
on CAN data and identifier patterns and you can set the bit sample
point.
• I2S (Inter- IC Sound or Integrated Interchip Sound bus) triggering—
consists of connecting the oscilloscope to the serial clock, word select,
and serial data lines, then triggering on a data value.
Agilent InfiniiVision 4000 X-Series Oscilloscopes
Programmer's Guide
28
:SBUS<n> Commands
on page 650
on page 668
on page 704
on page 723
on page 733
on page 747
on page 754
on page 770
on page 792
on page 944).
s1
on page 645
on page 647
on page 685
645