Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 370

18
:HARDcopy Commands
Table 93 :HARDcopy Commands Summary (continued)
Command
:HARDcopy:NETWork:PAS
Sword <password> (see
page 380)
:HARDcopy:NETWork:SLO
T <slot> (see
page 381)
:HARDcopy:NETWork:USE
Rname <username> (see
page 382)
:HARDcopy:PALette
<palette> (see
page 383)
n/a
:HARDcopy:STARt (see
page 385)
Introduction to
The HARDcopy subsystem provides commands to set and query the
:HARDcopy selection of hardcopy device and formatting options such as inclusion of
Commands
instrument settings (FACTors) and generation of formfeed (FFEed).
:HARDC is an acceptable short form for :HARDcopy.
Reporting the Setup
Use :HARDcopy? to query setup information for the HARDcopy subsystem.
Return Format
The following is a sample response from the :HARDcopy? query. In this
case, the query was issued following the *RST command.
:HARD:APR "";AREA SCR;FACT 0;FFE 0;INKS 1;PAL NONE;LAY PORT
370
Query
n/a
:HARDcopy:NETWork:SLO
T? (see page 381)
:HARDcopy:NETWork:USE
Rname? (see page 382)
:HARDcopy:PALette?
(see page 383)
:HARDcopy:PRINter:LIS
T? (see page 384)
n/a
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
Options and Query Returns
<password> ::= quoted ASCII
string
<slot> ::= {NET0 | NET1}
<username> ::= quoted ASCII
string
<palette> ::= {COLor | GRAYscale
| NONE}
<list> ::= [<printer_spec>] ...
[printer_spec>]
<printer_spec> ::=
"<index>,<active>,<name>;"
<index> ::= integer index of
printer
<active> ::= {Y | N}
<name> ::= name of printer
n/a