Trigger:eburst:slope - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

:TRIGger:EBURst:SLOPe

Command Syntax
:TRIGger:EBURst:SLOPe <slope>
<slope> ::= {NEGative | POSitive}
The :TRIGger:EBURst:SLOPe command specifies whether the rising edge
(POSitive) or falling edge (NEGative) of the Nth edge in a burst will
generate a trigger.
Query Syntax
:TRIGger:EBURst:SLOPe?
The :TRIGger:EBURst:SLOPe? query returns the current Nth edge in a
burst slope.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also
•
•
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
"Introduction to :TRIGger Commands"
":TRIGger:EBURst:IDLE"
":TRIGger:EBURst:COUNt"
on page 935
on page 956
on page 955
32
:TRIGger Commands
957