Power:switch:conduction - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

:POWer:SWITch:CONDuction

Command Syntax
:POWer:SWITch:CONDuction <conduction>
<conduction> ::= {WAVeform | RDS | VCE}
The :POWer:SWITch:CONDuction command specifies the conduction
calculation method:
• WAVeform — The Power waveform uses the original voltage waveform
• RDS — Rds(on) — The Power waveform includes error correction:
• VCE — Vce(sat) — The Power waveform includes error correction:
Query Syntax
:POWer:SWITch:CONDuction?
The :POWer:SWITch:CONDuction query returns the conduction calculation
method.
Return Format
<conduction><NL>
<conduction> ::= {WAV | RDS | VCE}
See Also •
•
•
•
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
data, and the calculation is: P = V x I
• In the On Zone (where the voltage level is below V Ref) – the Power
calculation is: P = Id2 x Rds(on)
Specify Rds(on) using the :POWer:SWITch:RDS command.
• In the Off Zone (where the current level is below I Ref) – the Power
calculation is: P = 0 Watt.
• In the On Zone (where the voltage level is below V Ref) – the Power
calculation is: P = Vce(sat) x Ic
Specify Vce(sat) using the :POWer:SWITch:VCE command.
• In the Off Zone (where the current level is below I Ref) – the Power
calculation is: P = 0 Watt.
":POWer:SWITch:APPLy"
":POWer:SWITch:IREFerence"
":POWer:SWITch:RDS"
":POWer:SWITch:VCE"
":POWer:SWITch:VREFerence"
on page 602
on page 604
on page 605
on page 606
on page 607
25
:POWer Commands
603