Measure:vstop - Agilent Technologies InfiniiVision 2000 X-Series Programmer's Manual

33
Obsolete and Discontinued Commands

:MEASure:VSTOp

Command Syntax
:MEASure:VSTOp <vstop_argument>
<vstop_argument> ::= value for Y2 cursor
The :MEASure:VSTOp command moves the vertical marker 2 (Y2 cursor) to
the specified value corresponding to the selected source. The source can
be selected by the MARKer:X2Y2source command.
The short form of this command, VSTO, does not follow the defined Long Form to Short
N O T E
Form Truncation Rules (see
both VSTArt and VSTOp, so sending VST for the VSTOp command produces an error.
The :MEASure:VSTOp command is an obsolete command provided for compatibility to
N O T E
previous oscilloscopes. Use the :MARKer:Y2Position command (see
Query Syntax
:MEASure:VSTOp?
The :MEASure:VSTOp? query returns the current value of the Y2 cursor.
Return Format
<value><NL>
<value> ::= value of the Y2 cursor in NR3 format
See Also
•
•
•
•
•
•
•
•
•
736
(see page 790)
"Introduction to :MARKer Commands"
"Introduction to :MEASure Commands"
":MARKer:Y1Position"
":MARKer:Y2Position"
":MARKer:YDELta" on page 329
":MARKer:X2Y2source"
":MEASure:SOURce"
":MEASure:TDELta" on page 727
":MEASure:TSTArt" on page 729
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
page 792). The normal short form, VST, would be the same for
on page 318
on page 340
on page 327
on page 328
on page 323
on page 361
page 328) instead.