Modular L3 Ethernet Switch User's Guide
Figure 6- 64. Trunk Balance Table window
The Trunk Balance Table window displays the following fields:
♦ Index – Identifies the trunk number.
♦ Forward Type – Balances the trunk in either 1 of 2 modes. The possible values are:
◊
Bridging
◊
Routing
♦ Layer – Specifies the Balance Layer that the trunk used for the specified Forward Type, the
possible values are:
◊
2 – Indicates that layer 2 is being used as the balance layer.
◊
3 – Indicates that layer 3 is being used as the balance layer.
◊
4 – Indicates that layer 4 is being used as the balance layer.
♦ Used Addresses – Specifies the network layer addresses used for balancing unicast frames.
The possible values are:
◊
NotApplied – Indicates that a network layer address is not used for balancing unicast
frames.
◊
DstAddr – Indicates that the destination address is used for balancing unicast
frames.
◊
ScrAddr – Indicates that the source address is used for balancing unicast frames.
◊
DstadnSrcAdd – Indicates that both the source and destination addresses are used
for balancing unicast frames.
◊
VlanID – Indicates that theVLAN ID is used for balancing unicast frames.
◊
EthType – Indicates that the ethernet type is used for balancing unicast frames.
♦ Broadcast Type – Specifies the criterion used for balancing L2 broadcast and unknown
frames. The possible values are:
◊
Common – A link allocated for broadcast and unknown frames is used for also for
unicast frames.
99