D-Link DES-6300 User Manual page 110

Modular L3 Ethernet Switch User's Guide
♦ Forward Transitions – Indicates the number of times the port has gone from a learning state
to a forwarding state.
To edit an entry in the Spanning Tree Port Table:
1. Display the Spanning Tree Port Table.
2. Double-click an entry in the Spanning Tree Port Table.
Click . The Spanning Tree Port Table - Edit window opens:
Figure 6- 75. Spanning Tree Port Table- Edit window
1. Edit the fields. The fields are the same as the Spanning Tree Port Table as described above.
2. Click . The Spanning Tree Port Table - Edit window closes.
3. Click . When the Status field displays "Finished!", the entry is saved to the device.
STP per VLAN
The following window applies to STP per device. STP can be implemented on a per VLAN basis.
Note: STP per VLAN isn't supported in the present software release.
Spanning Tree Parameters
The Spanning Tree Parameters window allows you to set the parameters for the Spanning Tree Mode.
To display the Spanning Tree Parameters window:
♦ Select Bridge > Spanning Tree > Parameters. The Spanning Tree Parameters window
opens:
or
110