D-Link DES-6300 User Manual page 73

Modular L3 Ethernet Switch User's Guide
◊
Per Port – Indicates the type of VLAN supported after the device is reset is per port
based.
◊
Per Protocol and Port – Indicates the type of VLAN supported after the device is reset
is per protocol and per protocol based.
To edit the VLAN Parameters:
♦ Click
. When the Status field displays "Finished!", the fields are confirmed as modified.
VLAN Table Per Port
The following window describes VLAN Table per port:
To display the VLAN Table window:
(Make sure Per Port is selected under "VLAN supported type after reset" on the Virtual LAN Parameters
window (Device > VLAN > VLAN Parameters)).
♦ Select Device > VLAN > VLAN Table. The VLAN Table opens:
Figure 6- 40. VLAN Table
The VLAN Table displays the following fields:
♦ IF Num – Identifies the VLAN interface number, automatically assigned by the management
station.
♦ Name – Identifies the user-defined name of the VLAN.
♦ Priority – Specifies the priority of the VLAN. The possible values are:
♦ MAC Address – Permanent VLAN MAC address, automatically assigned by the device. This
parameter applies to IP and IPX VLANs only, and is dependent on the VLAN address type.
♦ VLAN Address Type – If default the VLAN gets the device MAC address. If reserved the VLAN
is assigned a unique MAC address based on the order of which it was configured (0-4096
reserved MAC addresses). The address types to select from are as follows:
◊
Default – The default address.
◊
Reserve – User-defined address.
73