D-Link DES-6300 User Manual page 136

Modular L3 Ethernet Switch User's Guide
♦ Link State Database
♦ External Link State Database
♦ Neighbors Table
Parameters
To display OSPF parameters:
♦ Select Router > IP > OSPF II> Parameters. The OSPF Parameters window opens:
Figure 6- 105. OSPF Parameters window
The OSPF Parameters window displays the following fields:
♦ Administrative Status – The OSPF administrative status in the router. The field options are
the following:
◊
Enable – The OSPF process is active on at least one interface.
◊
Disable – The process is not active on any interface.
♦ Router ID – The router ID number. To ensure uniqueness the router ID must be equal to one
of the router IP addresses. By default, the router ID takes the IP Interface Address. Reset the
device to allow changes in the router ID to take effect.
♦ Number of External LSAs – The number of external Link-State Advertisements in the link-
state database.
♦ External LS Checksum Sum – The sum of LS checksums of external LS advertisements
contained in the LS database. Use this sum to determine if there has been a change in a router
LS database, and to compare the LS database of two routers.
♦ Leak RIP Routes – Controls the route redistribution from RIP into OSPF. When this
parameter is enabled, all routes inserted into the IP routing table via SNMP are advertised into
OSPF as external routes.
♦ Leak Static Routes – Controls route redistribution from static routes to RIP. When this
parameter is enabled, all static routes learned via static are advertised into RIP.
136