D-Link DES-6300 User Manual page 105

Modular L3 Ethernet Switch User's Guide
Figure 6- 70. Spanning Tree Parameters window General Parameters tab
The Spanning Tree Parameters window displays the following fields:
♦ General Parameters – Defines general information about the Spanning Tree Mode on a device
or VLAN, including the protocol specification, and if a port must belong to a VLAN. These
parameters can be modified.
♦ Bridge Setup Parameter – Identifies the root bridge's parameters.
♦ Root Parameters – Contains information regarding the root. These fields are grayed out and
cannot be modified. The fields appearing in this tab are grayed out.
♦ STP Setup Parameters – Contains information regarding the STP Setup. These fields are
grayed out and cannot be modified.
The General Parameters tab displays the following fields:
♦ Global STP Status – Indicates the STP status. The possible values are:
◊
Enabled – STP is enabled.
◊
Disabled – STP is disabled.
♦ STP Type – Indicates if the STP mode is per device or per VLAN.
♦ STP Type After Reset – Indicates the STP setting after the device is reset. The device must be
reset for the change to be implemented. The possible values are:
◊
Per Device – Indicates that the STP mode is per device.
◊
Per VLAN – Indicates that the STP mode is per VLAN.
Note: STP per VLAN isn't supported in the present software release.
♦ Protocol Specification – Indicates the protocol type. This field is a read only.
♦ Must belong to VLAN – Indicates if ports must belong to a defined VLAN. The possible values
are:
◊
True – Indicates that ports must belong to a defined VLAN to be in the STP mode.
105