D-Link DES-6300 User Manual page 177

Modular L3 Ethernet Switch User's Guide
3. Click the SAP Parameters button to modify IPX SAP parameters. The IPX SAP Parameters
window opens:
Figure 6- 152. IPX SAP Parameters window
The IPX SAP Parameters window displays the following parameters:
♦ Update Interval – SAP periodic update interval, in seconds. Set to 0 to disable periodic
messages. When set to 0, all entries learned on this interface are not aged out.
♦ Age Multiplier – Holding multiplier for information received in SAP periodic updates. This
value multiplied by the update interval defines how many seconds SAP information remains
without being refreshed. Set to 0 to prevent the entries learned on this interface from being aged
out.
♦ Respond to Get Nearest Server – Defines whether the device responds to SAP "get nearest
server" requests received on this circuit.
♦ Status – Defines whether the SAP interface is active. OFF is inactive but not deleted.
Note: The Update Interval multiplied by the Age Multiplier must be less than 2 million.
4. Complete the IPX SAP Parameters window fields if required.
5. Click. Close the IPX SAP Parameters window. The IPX Router Interface Parameters Edit
window is displayed.
6. Edit the fields.
7. Click .
8. Close the IPX Router Interface Parameters Edit window. The IPX Router Interface
Parameters window opens.
9. Click . When the Status field displays "Finished!", the fields are confirmed as modified.
To delete an IPX Router Interface entry:
1. Display the IPX Router Interface Parameters window.
2. Select an entry in the table.
3. Click . The entry is deleted.
4. Click . When the Status field displays "Finished!", the fields are confirmed as modified.
RIP/SAP Filter
The IPX RIP / SAP Filter table is used to display both global and circuit (IPX interface-specific) filters,
for both RIP and SAP. Circuit filters take precedence over global filters. To display the IPX RIP / SAP
Filter table:
177