D-Link DES-6300 User Manual page 183

Modular L3 Ethernet Switch User's Guide
5. Click .
6. Close the RIP Circuit Filter Edit window. The RIP Circuit Filter Table opens.
7. Click . When the Status field displays "Finished!", the fields are confirmed as modified.
To delete a RIP Circuit filter:
1. Display the RIP Circuit Filter Table.
2. Select an entry in the table.
3. Click . The filter is deleted.
4. Click . When the Status field displays "Finished!", the fields are confirmed as modified.
To display the SAP Global Filters:
1. Display the IPX RIP/SAP Filter window.
2. Press the SAP Global Filter button. The SAP Global Filter Table opens:
Figure 6- 160. SAP Global Filter Table window
The SAP Global Filter Table displays the following parameters:
♦ Type – Defines whether the current filter entry works on traffic coming into or out of the
device.
♦ Network Address – Type in the network pattern to affect the filter entry. The network pattern
works in conjunction with the network mask to define the filter entry.
♦ Network Mask – Type in the letters F, 8, C, E, and 0 as many times as desired to indicate
which part of the network pattern is important. The mask must be continuous from left to right.
00000000 means all addresses, ffffffff means one address (no address range). A combination of f
0 indicates a specific range. This combination must have f on the left side, 0 on the right side,
and a single F, 8, C, or E, or 0 between them.
For example, if the network pattern is set to 12345678, the network mask can be set to
ffff0000 to indicate that only the first four numbers of the network pattern are only
checked, and the remaining numbers are irrelevant. In this example, only SAP
messages with the numbers 1234 as their first four digits are affected.
♦ Service Type – Type in the type of server (in hex) the filter entry affects, such as file server or
print server. Value 0xFFFF applies for all types of service and is the default.
183