D-Link DES-6300 User Manual page 134

Modular L3 Ethernet Switch User's Guide
3. Click . The entry is deleted.
4. Click . When the Status field displays "Finished!", the fields are confirmed as modified.
To display IP Interface RIP Filter Table:
1. Display the IP Interface RIP Filter Table.
2. Select a filter in the table.
3. Click Interface Filter. The IP Interface RIP Filter Table opens:
Figure 6- 103. IP Interface RIP Filter Table window
The IP Interface RIP Filter Table displays the following fields:
♦ Type – The filter is for input or output.
♦ Status – The filter is valid or not.
♦ Network Address – The IP address network
♦ Number of Match Bits – The number of bits to match the network IP address. A value less
than 32 represents a wildcard.
♦ Filter Action – This parameter is used to fine-tune other filters. For example set a filter to
block all RIP messages with net address 192.114 and set another filter entry to permit all RIP
messages with the network 192.114.25. All RIP messages with the network 192.114 that do not
end in 25 are blocked.
◊
Permit – Whether the indicated packets should be forwarded.
◊
Deny – Whether the indicated packets should be blocked.
To add a RIP interface filter:
1. Display the IP Interface RIP Filter Table.
2. Click . The IP Interface RIP Filter Table Insert window opens:
134