D-Link DES-6300 User Manual page 129

Modular L3 Ethernet Switch User's Guide
♦ Leak OSPF Routes – Controls redistribution of routes from OSPF to RIP. When this
parameter is enabled, all routes learned via OSPF are advertised into RIP.
♦ Leak Static Routes – Controls redistribution of routes from static routes to RIP. When this
parameter is enabled, all static routes learned via static are advertised into RIP.
To edit RIP Parameter fields:
1. Display the RIP Parameters window.
2. Edit fields to Enable or Disable.
3. Click . When the Status field displays "Finished!", the fields are confirmed as modified.
RIP Interface Parameters
To display the RIP Interface Table:
♦ Select Router > IP > RIP > Interface Parameters. The RIP Interface Table opens:
Figure 6- 97. RIP Interface Table window
The RIP Interface Table displays the following fields:
♦ IP Address – Current IP address interfaces.
♦ Outgoing RIP – The type of RIP being sent.
◊
RIP Software version 1 – Sending RIP updates compliant with RFC 1058.
◊
RIP Software version 2 – Multicasting RIP2 updates.
◊
Do Not Send – No RIP updates are sent.
♦ Incoming RIP – The type of RIP being received.
◊
RIP Software version 1 – Accepting RIP1.
◊
RIP Software version 2 – Accepting RIP2.
♦ Do Not Receive – No RIP updates are accepted.
♦ Status – The RIP status in the router is either valid or invalid.
129