D-Link DES-6300 User Manual page 124

Modular L3 Ethernet Switch User's Guide
3. Click . The IP Address is deleted.
4. Click to update the device.
To display the ICMP Interface Parameters window:
1. Display the IP Router Interface Parameters Edit window.
2. Press the ICMP Parameters button. The ICMP Interface Parameters window opens:
Figure 6- 92. ICMP Interface Parameters window
The ICMP Interface Parameters window displays the following fields:
♦ IP Address – Interface IP address.
♦ Address for Router Advertisements – IP destination address for multicast Router
Advertisements sent from the interface. Possible values are the all-systems multicast address,
224.0.0.1, or the limited-broadcast address, 255.255.255.255.
♦ The Maximum Advertisements Interval – Maximum time in seconds between multicast
Router Advertisements from the interface. Possible values are between the minimum interval
defined below and 1800 seconds.
♦ The Minimum Advertisements Interval – Minimum time in seconds between sending
unsolicited multicast Router Advertisements from the interface. Possible values are between 3
seconds and the maximum interval defined above. Default value is 0.75 of the Maximum
Interval.
♦ The Advertisements Lifetime – Maximum time in seconds the advertised addresses are
considered valid. Must be no less than a Maximum Interval defined above, and no greater than
9000 seconds. Default value is 0.3 of the Maximum Interval.
♦ Advertise This Interface – Whether the address is advertised.
♦ The Preference Level of this Address – Preference address as a default router Default
address, relative to other router addresses on the same Subnet.
♦ Change all Parameters to Default – Resets all parameters in this window to their default
values.
124