Ipv4 Route Table; Ipv6 Static/Default Route Settings - D-Link DWS-3160-24TC Reference Manual

DWS-3160 Series Gigabit Ethernet Unified Switch Web UI Reference Guide

IPv4 Route Table

The IP routing table stores all the external routes information of the Switch. This window is used to display all the
external route information on the switch.
To view the following window, click L3 Features > IPv4 Route Table, as show below:
The fields that can be configured are described below:
Parameter
Network Address
IP Address
Hardware
Click the Find button to locate a specific entry based on the information entered.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

IPv6 Static/Default Route Settings

A static entry of an IPv6 address can be entered into the Switch's routing table for IPv6 formatted addresses.
To view the following window, click L3 Features > IPv6 Static/Default Route Settings, as show below:
The fields that can be configured are described below:
Parameter
Interface Name
Nexthop Address
Metric (1-65535)
Backup State
Figure 8-2 IPv4 Route Table window
Description
Click the radio button and enter the destination network address of the route to be
displayed.
Click the radio button and enter the destination IP address of the route to be displayed.
The longest prefix matched route will be displayed.
Tick the check box to display only the routes that have been written into the chip.
Figure 8-3 IPv6 Static/Default Route Settings window
Description
The IP Interface where the static IPv6 route is created.
The corresponding IPv6 address for the next hop Gateway address in IPv6 format.
The metric of the IPv6 interface entered into the table representing the number of
routers between the Switch and the IPv6 address above. Metric values allowed are
between 1 and 65535.
Each IP address can only have one primary route, while other routes should be
assigned to the backup state. When the primary route failed, the switch will try the
127