Lldp Port Settings - D-Link DWS-3160-24TC Reference Manual

DWS-3160 Series Gigabit Ethernet Unified Switch Web UI Reference Guide

LLDP Port Settings

On this page the user can configure the LLDP port parameters.
To view the following window, click L2 Features > LLDP > LLDP > LLDP Port Settings, as show below:
The fields that can be configured are described below:
Parameter
From Port / To Port
Notification
Admin Status
Subtype
Action
Address
Click the Apply button to accept the changes made.
NOTE: The IPv4 or IPv6 address entered here should be an existing LLDP management IP address.
Figure 7-90 LLDP Port Settings window
Description
Use the drop-down menu to select the ports used for this configuration.
Use the drop-down menu to enable or disable the status of the LLDP notification. This
function controls the SNMP trap however it cannot implement traps on SNMP when the
notification is disabled.
This function controls the local LLDP agent and allows it to send and receive LLDP
frames on the ports. This option contains TX, RX, TX And RX or Disabled.
TX - the local LLDP agent can only transmit LLDP frames.
RX - the local LLDP agent can only receive LLDP frames.
TX And RX - the local LLDP agent can both transmit and receive LLDP frames.
Disabled - the local LLDP agent can neither transmit nor receive LLDP frames.
The default value is TX And RX.
Use the drop-down menu to select the type of the IP address information will be sent.
Use the drop-down menu to enable or disable the action field.
Enter the IP address that will be sent.
118