D-Link DWS-3160-24TC Reference Manual page 410

DWS-3160 Series Gigabit Ethernet Unified Switch Web UI Reference Guide
•
•
•
•
After clicking the Manual Channel Plan tab, the following page will appear:
The fields that can be displayed are described below:
Parameter
5 GHz (802.11 a/n) / 2.4
GHz (802.11 b/g/n)
Current Status
AP MAC Address
Location
Radio
Current Channel
New Channel
The channel is not valid for the radio mode.
The AP has been rebooted since the channel plan was computed and acquires a static
channel that has been set statically via local database.
The channel has been set manually through the advanced page.
The auto-channel mode has been disabled in the profile for this AP.
Figure 3-13 RF Management Manual Channel Plan window
Description
The 5 GHz and 2.4 GHz radios use different channel plans, so the switch tracks
the channel history separately for each radio. The channel information that
displays is only for the selected radio.
Display one of the following status:
•
None - The channel plan algorithm has not been manually run since the last
switch reboot.
•
Algorithm In Progress - The channel plan algorithm is running.
•
Algorithm Complete - The channel plan algorithm has finished running.
•
Apply In Progress - The switch is applying the proposed channel plan and
adjusting the channel on the APs listed in the table.
•
Apply Complete - The algorithm and channel adjustment are complete.
The Ethernet address of the Unified Wireless Switch managed AP. If the MAC
address of the AP is followed by an asterisk (*), it is managed by a peer switch.
A location description for the AP, this is the value configured in the valid AP
database (either locally or on the RADIUS server).
Display the radio interface and configured mode of the radio, if the radio is
disabled the radio mode will be displayed as Off instead of showing the
configured mode.
Display the current operating channel for the AP that the algorithm recommends
for new channel assignments.
Display the proposed operating channel for the AP.
405