D-Link DWS-3160-24TC Reference Manual page 366

DWS-3160 Series Gigabit Ethernet Unified Switch Web UI Reference Guide
Physical Mode
Security Mode
802.11n Mode
Beacon Interval
Highest Supported Rate
Peer Managed AP
Ad hoc Network
OUI Description
After clicking the AP Triangulation Status tab, the following page will appear:
The fields that can be displayed are described below:
Parameter
Detected AP MAC
Address
Sentry
MAC Address
Radio
RSSI(%)
Signal Strength(dBm)
Noise Level(dBm)
Age
Display the 802.11 mode being used on the AP.
Security mode used by the AP.
Display whether this AP supports IEEE 802.11n mode.
Beacon interval for the neighbor AP network.
Highest supported rate advertised by this AP in the beacon frames. The rate is
represented in increments of 1 Mbps.
Display whether this AP is managed by a switch in the cluster.
Display whether the beacon frame was received from an ad hoc network.
Display the manufacturer of the AP or wireless client adapter based on the
information in the OUI database on the switch.
Figure 2-31 AP RF Scan Status – AP Triangulation Status window
Description
The Ethernet MAC address of the detected AP. This could be a physical radio
interface or VAP MAC. For D-Link APs this is always a VAP MAC address.
Display whether the AP that detected the entry is in sentry or non-sentry mode.
Display the MAC address of the AP that detected the RF Scan entry. The address
links to the Valid AP database.
Display the radio on the AP that detected the RF Scan entry.
Display the received signal strength indicator in terms of percentage for the non-
sentry AP. The range is from 0 to 100%. A value of 0 indicates the AP is not
detected.
Received signal strength for the non-sentry AP. The range is from -127 dBm to 127
dBm, but most values are expected to range from -95 dBm to -10 dBm.
Noise reported on the channel by the non-sentry AP.
Time since this AP was last detected in an RF scan.
361