D-Link DWS-3160-24TC Reference Manual page 355

DWS-3160 Series Gigabit Ethernet Unified Switch Web UI Reference Guide
The fields that can be displayed are described below:
Parameter
Neighbor AP MAC
SSID
RSSI
Status
Age
Click the Neighbor AP MAC hyperlink to see the detail information about AP RF Scan Status.
Click the Delete All Neighbors to remove all the neighbor entries.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After clicking the Neighbor Clients tab under the Status tab, the following page will appear:
Use the drop down menu to select AP's MAC address and use the radio button to select a radio to view the
neighbor clients detected via an RF scan on that radio.
The fields that can be displayed are described below:
Parameter
Description
The Ethernet MAC address of the neighbor AP network, this could be a physical
radio interface or VAP MAC address. For D-Link APs this is always a VAP MAC
address. The neighbor AP MAC address may be cross-referenced in the RF Scan
status.
Service Set ID of the neighbor AP network.
Received Signal Strength Indication, this is an indicator of the signal strength
relative to the neighbor and may give an idea of the neighbor's distance from the
managed AP. The range is from 1 to 100, where 1 is the weakest signal strength.
Indicate the managed status of the AP, whether this is a valid AP known to the
switch or a Rogue on the network. The valid values are:
•
Managed - The neighbor AP is managed by the wireless system.
•
Standalone - The AP is managed in standalone mode and configured as a valid
AP entry (local or RADIUS).
•
Rogue - The AP is classified as a threat by one of the threat detection
algorithms.
•
Unknown - The AP is detected in the network but is not classified as a threat by
the threat detection algorithms.
Indicate the time since this AP was last reported from an RF scan on the radio.
Figure 2-18 Managed AP Status – Neighbor Clients window
Description
350