D-Link DWS-3160-24TC Reference Manual page 350

DWS-3160 Series Gigabit Ethernet Unified Switch Web UI Reference Guide
Configuration Status
Age
Click the MAC Address hyperlink to see the detail of the AP.
Tick the corresponding check box, and click the Delete button to remove the specific entry.
Click the Delete All button to remove all the entries listed.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After clicking the Detail tab under the Status tab, the following page will appear:
Use the drop-down menu to select the MAC address of the AP to see the detail information.
The fields that can be displayed are described below:
Parameter
IP Address
IP subnet Mask
Status
This status indicates if the AP is configured successfully with the assigned profile.
The status is one of the following:
•
Not Configured - The profile has not been sent to the AP yet, the AP may be
discovered but not yet authenticated.
•
In Progress - The switch is currently sending the AP profile configuration
packet to the AP.
•
Success - The entire profile has been sent to the AP and there were no
configuration errors.
•
Partial Success - The entire profile has been sent to the AP and there were
configuration errors (for example, some configuration parameters were not
accepted), but the AP is operational.
•
Failure - The profile has been sent to the AP and there were configuration
errors, the AP is not operational.
Time since last communication between the Unified Switch and the AP.
Figure 2-14 Managed AP Status - Detail window
Description
The IP address of the managed AP.
The subnet mask of the managed AP
The current managed state of the AP. The possible values are:
•
Discovered - The AP is discovered and by the switch, but is not yet
authenticated.
•
Authenticated - The AP has been validated and authenticated (if authentication
345