Dhcp Relay Option 60 Server Settings; Dhcp Relay Option 60 Settings - D-Link DWS-3160-24TC Reference Manual

DWS-3160 Series Gigabit Ethernet Unified Switch Web UI Reference Guide
this window. Properly configured settings will be displayed in the DHCP Relay Interface Table at the bottom of the
window, once the user clicks the Apply button. The user may add up to four server IPs per IP interface on the
Switch. Entries may be deleted by clicking the corresponding Delete button.
To view this window, click Network Application > DHCP > DHCP Relay > DHCP Relay Interface Settings as
shown below:
The fields that can be configured are described below:
Parameter
Interface Name
Server IP Address
Click the Apply button to accept the changes made.

DHCP Relay Option 60 Server Settings

This window is used to configure the DHCP relay option 60 server parameters.
To view this window, click Network Application > DHCP > DHCP Relay > DHCP Relay Option 60 Server
Settings as shown below:
The fields that can be configured are described below:
Parameter
Server IP Address
Mode
Click the Add button to add a new entry based on the information entered.
Click the Apply button to accept the changes made.
Click the Delete button to remove the specific entry.
Click the Delete All button to remove all the entries listed.
NOTE: When there is no matching server found for the packet based on option 60, the relay servers
will be determined by the default relay server setting.

DHCP Relay Option 60 Settings

Figure 12-4 DHCP Relay Interface Settings window
Description
The IP interface on the Switch that will be connected directly to the Server.
Enter the IP address of the DHCP server. Up to four server IPs can be configured per
IP Interface.
Figure 12-5 DHCP Relay Option 60 Server Settings window
Description
Enter the DHCP Relay Option 60 Server Relay IP Address.
Use the drop-down menu to select the DHCP Relay Option 60 Server mode.
269