D-Link DWS-3160-24TC Reference Manual page 160

DWS-3160 Series Gigabit Ethernet Unified Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Profile ID (1-6)
Select ACL Type
IPv6 Class
IPv6 Flow Label
IPv6 TCP
IPv6 UDP
Figure 10-13 Add ACL Profile window (IPv6 ACL)
Description
Enter a unique identifier number for this profile set. This value can be set from 1 to
6.
Select profile based on Ethernet (MAC Address), IPv4 address, IPv6 address, or
packet content. This will change the window according to the requirements for the
type of profile.
Select Ethernet ACL to instruct the Switch to examine the layer 2 part of each
packet header.
Select IPv4 ACL to instruct the Switch to examine the IPv4 address in each
frame's header.
Select IPv6 ACL to instruct the Switch to examine the IPv6 address in each
frame's header.
Select Packet Content to instruct the Switch to examine the packet content in each
frame's header.
Ticking this check box will instruct the Switch to examine the class field of the IPv6
header. This class field is a part of the packet header that is similar to the Type of
Service (ToS) or Precedence bits field in IPv4.
Ticking this check box will instruct the Switch to examine the flow label field of the
IPv6 header. This flow label field is used by a source to label sequences of
packets such as non-default quality of service or real time service packets.
Source Port Mask – Specify that the rule applies to the range of TCP source ports.
Destination Port Mask – Specify the range of the TCP destination port range.
Source Port Mask – Specify the range of the TCP source port range.
Destination Port Mask – Specify the range of the TCP destination port mask.
155