Qinq Settings; Vlan Translation Settings - D-Link DWS-3160-24TC Reference Manual

DWS-3160 Series Gigabit Ethernet Unified Switch Web UI Reference Guide

QinQ Settings

This window is used to configure the Q-in-Q parameters.
To view the following window, click L2 Features > QinQ > QinQ Settings, as show below:
The fields that can be configured are described below:
Parameter
QinQ State
Inner TPID
From Port / To Port
Role
Missdrop
Outer TPID
Add Inner Tag
Click the Apply button to accept the changes made for each individual section.

VLAN Translation Settings

This window is used to add translation relationship between C-VLAN and SP-VLAN. On ingress at UNI port, the C-
VLAN tagged packets will be translated to SP-VLAN tagged packets by adding or replacing according the
Figure 7-26 QinQ Settings Window
Description
Click to enable or disable the Q-in-Q state.
Enter an Inner TPID in SP-VLAN tag here.
Use the drop-down menus to select a range of ports to use in the configuration.
Port role in Q-in-Q mode, it can be UNI port or NNI port
This option enables or disables C-VLAN based SP-VLAN assignment miss drop. If
Missdrop is enabled, the packet that does not match any assignment rule in the Q-in-Q
profile will be dropped. If disabled, then the packet will be forwarded and will be assigned
to the PVID of the received port.
Enter an Outer TPID in SP-VLAN tag here.
Specifies that an Inner Tag will be added to the entry. By default the Disabled option is
selected.
71