D-Link DWS-3160-24TC Reference Manual page 431

DWS-3160 Series Gigabit Ethernet Unified Switch Web UI Reference Guide
L3 Tunnel Mask
RADIUS Use Network
Configuration
RAIDUS Accounting
Security Option
Enter the subnet mask for the network IP address on the L3 Tunnel subnet.
This parameter is used to control whether the VAP uses the network or global
RAIDUS Accounting settings. Select Enable to use RADIUS accounting settings
defined on the Wireless Network Configuration page. Select Disable to use
RADIUS accounting settings defined on the Wireless Global Configuration page.
Tick the check box to enable RADIUS accounting for wireless clients.
Select the security mechanism of the wireless connection to protect the network.
None Select this for not having any security of the network, and no further
options are configurable on the AP.
WEP Wired Equivalent Privacy (WEP) is a data encryption protocol for
802.11 wireless networks. If this security mechanism is selected, all
wireless clients and access points on the network are configured
with a 64-bit or 128-bit Shared Key for data encryption. Select WEP
to see the following options.
Static WEP – Select Static WEP to configure the static key
management. The following options will display:
•
•
•
•
WEP IEEE802.1X – Select WEP IEEE802.1X to see the following
options:
•
•
Authentication – Tick the check boxes to select the
authentication type. Available options are Open System
and Shared Key.
WEP Key Type – Click the radio buttons to select the key
type. Available options are ASCII and HEX. ASCII key
includes upper and lower case alphabetic letters, the
numeric digits, and special symbols such as @ and #. HEX
key includes digits 0 to 9 and the letters A to F.
WEP Key Length (bits) – Click the radio button to select
the key length in 64 bits or 128 bits.
WEP Keys – Click the radio button to select the specific
transfer key. Enter up to 4 WEP keys in the text fields. The
length of keys depends on the WEP Key Type and WEP
Key Length configured earlier.
Bcast Key Refresh Rate – Enter a value to set the interval
at which the broadcast key is changed for clients associated
to this VAP.
Session Key Refresh Rate – Enter a value to set the
interval at which the Unicast session keys is changed.
426