Table of Contents
Advertisement
AltiGatekeeper Installation
When installing AltiGatekeeper, the installation will require information in
the following dialog box.
Figure 5. AltiGatekeeper Configuration Tool configuration window
Note:
The user can change this configuration later by running the
program CONFIGTOOL.EXE in the AltiGatekeeper installation
directory.
In this configuration dialog box, if NAT is not used, you should only
configure the Public Access Redirect Address and uncheck the Enable
Private Access check box. The Redirect Address for Public Access is
AltiWare's public IP address or the NAT's public IP address if AltiWare
only has the private IP address. If the private IP address was used for
AltiWare or the local IP phone, the Enable Private Access should be
checked to allow the IP phones, which are configured with private IP
addresses, to access the gatekeeper and AltiWare. For Private Access, the
Redirect Address is AltiWare's private IP address; and the Subnet
Address and Subnet Mask are used to describe the private network.
IP Phone Configuration
When configuring the IP phone (which can apply to an H.323 client, such
as NetMeeting integrated with AltiView), you should set up the phone to
work in either gatekeeper mode or gateway mode. In gatekeeper mode,
you should which gatekeeper you want this IP phone to register to. Thus
you will need the IP address of the specify the server's IP address, referred
AltiContact Manager Administration Manual
VoIP Configuration
9-13
Advertisement
Table of Contents
Troubleshooting
