Altigen AltiContact Manager Version 5.0 Administration Manual page 274

Setting Up an AltiContact Manager-to-AltiContact Manager IP Network
4. Configure the dialing plan for connection to remote AltiContact
Manager systems on the IP Dialing Table tab window of System
Configuration. Set the Number of Dialed Digits to "None." Refer to
"Defining the IP Dialing Table" on page 9-2.
5. Set the VoIP codecs so that servers use the same codec. See "Setting
VoIP Codecs" on page 9-5.
6. Repeat steps 1 through 5 for all local and remote AltiContact Manager
systems that are to be networked via tie-trunk line connection.
This completes the AltiContact Manager-to-AltiContact Manager network
connection. Your organization is now ready to make and receive IP trunk
calls through public or private IP networks.
Note:
Extension users should refer to the AltiView and AltiServ User
Guide for instructions on how to dial a remote AltiContact
Manager. Also, be sure to distribute the Remote Locations Dialing
Chart with your organization's unique dialing plan. This chart is
available in the AltiView and AltiServ User Guide.
9-32 AltiContact Manager Administration Manual