Altigen AltiContact Manager Version 5.0 Administration Manual page 233

Parameter
Incoming
sequence
Or
Apply to...
Note:
In order for back-to-back T1 and tie trunk T1 configurations to
perform properly, it is recommended that you use the system's
default incoming call sequences:
Description
Select up to five incoming symbols to collect from the
Caller ID or DID digits:
• None
• #
• *
• # or *
• Caller ID
• DID/DNIS
Selecting 'None' in any field of the sequence will terminate
the sequence and automatically disable subsequent entries
in the sequence.
The default sequence is:
"# or *" (and then) "Caller ID" (and then) "# or *" (and
then) "DID/DNIS"
Sets up an additional, alternative sequence. You can select
another set of up to five incoming symbols to collect.
Not checking any box is equivalent to checking 'None' in
the first field.
The default sequence is:
"DID/DNIS"
If appropriate, you can use this button, as described in
"Configuring One or Multiple Trunks" on page 7-2, to
apply the Caller ID Collection to multiple T1 trunks.
AltiContact Manager Administration Manual
Trunk Configuration
7-19